Our injection molded 3I Series of Mil-Standard waterproof cases continues to grow with three new sizes totaling six new configurations. The 3I-1611-6B is available in four interior configurations including cubed foam, layered foam, padded dividers, and empty. The 3I-0907-6B adds a new interior consisting of two separate layers of three inch deep padded dividers, each independently adjustable that stack together to fit snugly in the interior of this six inch deep case. The The new 3I-1914-8B-D introduces an interior divider option to this pull-handle case size.

New 3I Series Cases:

These Mil-Standard cases are injection molded of a rugged Polypropylene Co-polymer that is virtually impervious to damage. These new cases and the entire SKB 3I Series line meet or exceed the following military certifications. Lab results are on file and available at our design headquarters in Orange, CA.

Military specification for protection against dust and against the effect of immersion between 15cm and 1m.

Military specification for automatic ambient pressure equalization valve.

Military specification for resistance to UV, solvents, corrosion, fungus and impact damage.

Military specification for waterproof and water-vapor proof cases for transit and storage.

These and all SKB Brand Hard Case Products are fully warranted against defects in materials and craftsmanship for the life of the case to the original owner. That means, if your case breaks, SKB will repair or replace it at no cost to you for as long as you own the case.